For professional fast efficient cleaning of dryer vents we recommend the following Dryer Vent Cleaning Package. Plugged vents are easy to clean with this package. Recommended start up pressure, 150 PSI or higher. Smaller compressors will get the job done but run out of air very quickly. |
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
DRYER VENT CLEANING PARTS (1/4" fittings)
 |
Blue Skipper Line with SK6W Reverse Blowing Skipper Ball. When cleaning dryer vents from the outside of the building, this will clean most vents for you. | ||||||||||||||||||||||
|
|||||||||||||||||||||||
 |
Blue Skipper Line with SK3 Reverse Blowing Spinning Ball. This can travel as much as 40' through 5 elbows and beyond. The best dryer vent tool made. Blue Skipper Line can only be used with reverse blowing tools |
||||||||||||||||||||||
|
|||||||||||||||||||||||
 |
Dryer Vent Snake The snake is usually used from the inside of the building. This snake has the scorpion female quick disconnect fitting on one end which enables you to interchange the agitation devices. It is stiff enough to be used with forward blowing scorpion tools and has enough stiffness to break up bird nests. Longer lengths available. Add Cdn$5.25 for every 5 feet. E.g. 30' Snake for Cdn$60.50 |
||||||||||||||||||||||
|
|||||||||||||||||||||||
| SS4 |
 |
#4 Forward Blowing Skipper Ball for Scorpion. | |||||||||||||||||||||
| Used to loosen and push debris away from you towards the suction hose. Comes with male scorpion QD (SS5). | |||||||||||||||||||||||
| SS6 |
 |
#6 Reverse Blowing Skipper Ball for Scorpion. | |||||||||||||||||||||
| Used to loosen and pull debris towards you and the suction hose. Comes with make scorpion QD (SS5). | |||||||||||||||||||||||
| SS9 |
 |
#3 Reverse Blowing Spinning Ball for Scorpion. Improved Spinning Power. | |||||||||||||||||||||
| Excels in small round ductwork especially in dryer vents. Used on the end of the 20' snake, this spinning skipper ball will pull the snake around elbows. Comes with male scorpion QD (SS14). | |||||||||||||||||||||||
| SS10 |  |
#5 Forward Blowing Spinning Ball for Scorpion. | |||||||||||||||||||||
| Excels in small round ductwork especially in dryer vents. Because the end is alive or moving around all the time it finds its way around elbows much easier than other tools. Comes with male scorpion QD (SS14). | |||||||||||||||||||||||
| DVBG2 (1/4" fittings) |
 |
Ball Valve with Female Quick Disconnect. | |||||||||||||||||||||
| Female QD (2FM2) Male QD (D2M2) |
|||||||||||||||||||||||
| DV240 (1/4" fittings) |
 |
Thumb Valve with Female Quick Disconnect. | |||||||||||||||||||||
| Female QD (2FM2) Male QD (D2M2) |
|||||||||||||||||||||||
